Klark-Teknik DN27 27-Band Graphic Equalizer Made in Britain
Save 55%
Original price
$664.99
Original price
$664.99
-
Original price
$664.99
Original price
$664.99
Current price
$299.99
$299.99
-
$299.99
Current price
$299.99
The Klark-Teknik DN27 is an amazing 27-band equalizer perfect for studio recording and audio alteration. It's great for professionals wanting the best performance and flexibility possible.
CONDITION
SPENCERTIFIED- Fully certified by Spencer
Refurbished and SPENCERTIFIED
Every function has been confirmed 100% working. We have cleaned it inside and out and replaced any worn parts.
Cosmetic Condition: Very Good.
Functional Condition: Works Like New .
WHAT'S IN THE BOX?
- Klark-Teknik DN27 27-Band Graphic Equalizer Made in Britain
- Power Cord
Other information about the Klark-Teknik DN-27
- Bands: 27 filters with centers at 40, 50, 63, 80, 100, 125, 160, 200, 250, 315, 400, 500, 630, 800, 1K, 1.25K, 1.6K, 2K, 2.5K, 3.15K, 4K, 5K, 6.3K, 8K, 10K, 12.5K, 16KHz
- Power on/off is by a two-pole toggle switch (which disconnects live and neutral lines when off)
- Power status is indicated by a red led
- The input level control facilitates input-output system gain of up to 6dB when fully clockwise, and full attenuation of input signal when anti-clockwise
- For instant A-B comparison between dry and equalized output an "eq" bypass switch is provided
- Each fader has a travel length of 60mm giving high resolution of settings, and a center detent allowing accurate "flat" or OdB setting
- Mains inlet is via an IEC standard 3-pin socket
- A separate holder contains the main fuse
- An earth lift switch is provided on the rear panel
- Centre Frequency Accuracy: Better than t2% of nominal
- Calibration Accuracy: ±O. 5dB
- Frequency Response: ±0.5dB,20-20KHz with controls flat
- Output Clipping Point: +23d8m (11v) into 600 ohm load
- Distortion: Less than 0.01% 1KHz at +4d8m into 600 ohm load. Less than 0105% 20Hz-20KHz at +18d8m into 600 ohm load
- Equivalent Input Noise: Less than -95dBm 20Hz-20KHz unweighted.
- Dynamic Range: Gre~ter than 115dB
- Input Impedance: 10K ohms nominal
- Output Source Impedance: 56 ohms short circuit protected
- Bypass: Equalizer bypass via front panel control. System bypass via gold contact relay during "power down" or when unit switched off
- Power Requirements: 200-240v A.C (100 to 120v internally switchable) 50-60Hz at 5VA
DIMENSIONS
- 19" x 8.4" x 5.4" (Length x Width x Height)
INPUTS
- 3-pin XLR socket x1 (back)
- Power In x1 (back)
OUTPUTS
- 3-pin XLR socket x1 (back)
MANUFACTURER
- Made in England
