Dynaco Stereo 150 Stereo Power Amplifier 75WPC Wood Side Panels
Bring classic American hi-fi power to your stereo system with the Dynaco Stereo 150. This solid-state power amplifier delivers 75 watts per channel into 8 ohms, with enough output to drive a wide variety of vintage and modern passive speakers. Its minimalist brushed-aluminum face, black center panel, wood side panels, and oversized rear heat sinks create a distinctive early-1970s appearance. Fully tested, refurbished, and ready to pair with a compatible stereo preamplifier.
CONDITION
SPENCERTIFIED- Fully certified by Spencer
Refurbished and SPENCERTIFIED
100% tested and functional. Cleaned inside and out; worn parts replaced as needed. Internal boards, power-supply components, wiring, RCA connections, speaker terminals, fuses, heat sinks, and solder joints were inspected. Appropriate electrical contacts were cleaned with WD-40 Specialist Electrical Contact Cleaner, which is safe for electronics. DC offset and amplifier bias were checked, and both channels were tested under load for clean, balanced output.
Cosmetic Condition: 9/10
Functional Condition: 10/10
📦 Professionally packed and shipped with care.
WHAT'S IN THE BOX?
- Dynaco Stereo 150 Stereo Power Amplifier 75WPC Wood Side Panels
- Speaker Wire
- Manual
Other information about the Dynaco Stereo 150
- Power output: 75 watts per channel into 8Ω (stereo)
- Frequency response: 20Hz to 20kHz
- Total harmonic distortion: 0.25%
- Damping factor: 50
- Input sensitivity: 1V
- Signal to noise ratio: 95dB
- Speaker load impedance: 4Ω to 16Ω
- Semiconductors: 24 x transistors, 2 x zener diodes, 16 x diodes, 2 x thermal sensors
- Two-channel solid-state stereo power amplifier
DIMENSIONS
- Size: 14.25" x 13.5" x 7" (Length x Width x Height)
- Weight: 29 lbs
INPUTS
- Channel Input x2 (back)
OUTPUTS
- Channel Speaker x1 L/R (back)
MANUFACTURE DATE
- Made in the U.S.A
