Kenwood KR-770 AM/FM Stereo Receiver Silver Face Vintage (1980)
The Kenwood KR-770 is a classic stereo receiver featuring warm analog sound and timeless silver-face styling. Built during the golden era of hi-fi, it delivers clean power, strong tuner performance, and a straightforward control layout. With its solid construction and smooth tuning dial, this receiver is an excellent foundation for a vintage vinyl or tape-based system. Fully tested and operating properly, it’s ready to bring classic Kenwood sound back to your setup. SpenCertified and ready to perform.
CONDITION
SPENCERTIFIED- Fully certified by Spencer
Refurbished and SPENCERTIFIED
100% tested and functional. Cleaned inside and out; worn parts replaced as needed. Controls, switches, and boards cleaned with WD-40 Specialist Electrical Contact Cleaner (safe for electronics). All pots and selector switches were serviced. DC offset checked and verified within safe operating range. AM/FM tuner tested for stable reception. Dial lamps were inspected and replaced as needed.
Cosmetic Condition: 8/10 (wood cabinet side panel has cosmetic damage)
Functional Condition: 10/10
📦 Professionally packed and shipped with care.
WHAT'S IN THE BOX?
- Kenwood KR-770 AM/FM Stereo Receiver Silver Face Vintage (1980)
- Analog Audio Cable
Other information about the Kenwood KR-770
- Tuning range: FM, MW
- Power output: 80 watts per channel into 8Ω (stereo)
- Frequency response: 1Hz to 320kHz
- Total harmonic distortion: 0.02%
- Damping factor: 60
- Input sensitivity: 2.5mV (mic), 2.5mV (MM), 150mV (DIN), 150mV (line)
- Signal to noise ratio: 70dB (mic), 83dB (MM), 105dB (line)
- Output: 150mV (line), 30mV (DIN)
- Speaker load impedance: 4Ω (minimum)
- Tape monitor loop
- Bass and treble tone controls
- Balance control
- Loudness switch
- Speaker A/B selection
- Headphone output
- Analog signal strength and tuning meters
- Brushed aluminum silver faceplate
- Wood cabinet styling
- Frequency Response: 20Hz–20kHz
DIMENSIONS
- Size: 21.1" W x 5.2" H x 14.3" D
- Weight: 26.5 lb
INPUTS
- Mic x1 (front)
- Phono x1 L/R (back)
- AUX x1 L/R (back)
- Tape x4 L/R (back)
- Tape x1 (back)
OUTPUTS
-
Headphones Jack x1 (front)
- Speakers x2 L/R (back)
MANUFACTURE PLACE
- Made in Japan
- MFD: 1980
