Pioneer SR-202 Vintage Solid State Reverberation Amplifier (1970)
Looking to own a nice piece of Pioneer history? The Pioneer SR-202 is a reverb amplifier that can be used to increase the naturalness of your own recorded voice, radio broadcasts, records, or tapes. You can couple it with your amplifier (just use the tape monitor jacks) in a few different ways to add some cool reverberation effects to your speakers, to the recorded sounds, or both. You can even control two tape recorders at the same time for simultaneous recording, recording with reverberation, playback, etc. Plus, it uses dual time delay circuits to eliminate any peaks or dips in reverberation so what you get is stable audio that has tremendous depth and brilliance.
Basically, it plugs in just like a signal processor such as an equalizer or dynamic range enhancer. It's not for everyone, but if you enjoy a bit of reverb, the Pioneer SR-202 is an excellent choice. And who could say no to it's beautiful silver face bordered with wood in a combination that just screams vintage?
CONDITION
SPENCERTIFIED- Fully certified by Spencer
Refurbished and SPENCERTIFIED
Every function has been confirmed 100% working. We have cleaned it inside and out and replaced any worn parts. A recap was performed if necessary. All pots, knobs, connectors and boards have been cleaned with CRC cleaner.
Cosmetic Condition: Very Good.
Functional Condition: Works Like New.
WHAT'S IN THE BOX?
- Pioneer SR-202 Vintage Solid State Reverberation Amplifier
- Analog Audio Cable
Other information about the Pioneer SR202
- Input level: 200mV (3V maximum)
- Output voltage: 330mV
- Harmonic distortion: 0.2%
- Frequency response: 20Hz to 35kHz
- Signal to noise ratio: 65dB
- Reverberation time: 1.9 to 3.2s
- Silver face equipment
DIMENSIONS
- 300 x 115 x 250mm (LxHxD)
- Weight: 4.0kg
INPUTS
- Reverberation Amp L/R x1 (back)
- Tape L/R x2 (back)
OUTPUTS
- Reverberation Amp L/R x1 (back)
- Tape L/R x2 (back)
- AC Outlets x2 (back)
MANUFACTURER
- Made in Japan
