Klark-Teknik DN27 27-Band Graphic Equalizer Made in Britain-Equalizers-SpenCertified-vintage-refurbished-electronics

Klark-Teknik DN27 27-Band Graphic Equalizer Made in Britain

by SpenCertified

Save 25%

$664.99

$499.99

Quantity

The Klark-Teknik DN27 is an amazing 27-band equalizer perfect for studio recording and audio alteration. It's great for professionals wanting the best performance and flexibility possible.

CONDITION

SPENCERTIFIED- Fully certified by Spencer

Refurbished and SPENCERTIFIED

Every function has been confirmed 100% working. We have cleaned it inside and out and replaced any worn parts.

Cosmetic Condition: Very Good.

Functional Condition: Very Good.

WHAT'S IN THE BOX?

Klark-Teknik DN27 27-Band Graphic Equalizer Made in Britain
Power Cord

Other information about the Klark-Teknik DN-27

Bands: 27 filters with centers at 40, 50, 63, 80, 100, 125, 160, 200, 250, 315, 400, 500, 630, 800, 1K, 1.25K, 1.6K, 2K, 2.5K, 3.15K, 4K, 5K, 6.3K, 8K, 10K, 12.5K, 16KHz
Power on/off is by a two-pole toggle switch (which disconnects live and neutral lines when off)
Power status is indicated by a red led
The input level control facilitates input-output system gain of up to 6dB when fully clockwise, and full attenuation of input signal when anti-clockwise
For instant A-B comparison between dry and equalized output an "eq" bypass switch is provided
Each fader has a travel length of 60mm giving high resolution of settings, and a center detent allowing accurate "flat" or OdB setting
Mains inlet is via an IEC standard 3-pin socket
A separate holder contains the main fuse
An earth lift switch is provided on the rear panel
Centre Frequency Accuracy: Better than t2% of nominal
Calibration Accuracy: ±O. 5dB
Frequency Response: ±0.5dB,20-20KHz with controls flat
Output Clipping Point: +23d8m (11v) into 600 ohm load
Distortion: Less than 0.01% 1KHz at +4d8m into 600 ohm load. Less than 0105% 20Hz-20KHz at +18d8m into 600 ohm load
Equivalent Input Noise: Less than -95dBm 20Hz-20KHz unweighted.
Dynamic Range: Gre~ter than 115dB
Input Impedance: 10K ohms nominal
Output Source Impedance: 56 ohms short circuit protected
Bypass: Equalizer bypass via front panel control. System bypass via gold contact relay during "power down" or when unit switched off
Power Requirements: 200-240v A.C (100 to 120v internally switchable) 50-60Hz at 5VA

DIMENSIONS

19" x 8.4" x 5.4" (Length x Width x Height)

INPUTS

3-pin XLR socket x1 (back)
Power In x1 (back)

OUTPUTS

3-pin XLR socket x1 (back)

MANUFACTURER

Made in England

Shop By

All Products

Klark-Teknik DN27 27-Band Graphic Equalizer Made in Britain

SpenCertified

Shopper's Assistance